EFFECT OF SILICON RUBBER (SIR) IN FABRICATION OF NdFeB/BaFe12O19-BASED HYBRID MAGNET
DOI:
10.29303/ipr.v7i1.258Downloads
Abstract
The purpose of this study was to determine the effect of physical properties (density), magnetic properties (magnetic flux), and mechanical properties (tensile strength) of NdFeB- BaFe12O19 hybrid magnets with silicon rubber adhesive. NdFeB - BaFe12O19 permanent magnet has been made with a silicon rubber (SIR) adhesive mixture. The percentage variations of magnetic powder materials used are NdFeB: BaFe12O19 (95%: 5%) and NdFeB: BaFe12O19 (90%: 10%) mixed with a weight percentage of silicone rubber with variations of 20%, 40%, 60% and 80%. Characterization includes physical properties in the form of density where the sample with 20% SIR variation has the largest bulk density value of 3.28 g/cm3 for NdFeB: BaFe12O19 (95%: 5%) and 3.24 g/cm3 for NdFeB: BaFe12O19 (90%: 10%), and mechanical properties in the form of tensile strength where the most optimum elasticity value is at 80% silicone rubber. Meanwhile, the most optimum magnetic properties of materials are owned by material samples with variations of SIR at a concentration of 20% for sample variations of 95% NdFeB and 5% BaFe12O19, which is 602.8 Gauss.
Keywords:
Neodymium Iron Boron (NdFeB), Barium Heksafererrite, Silicone rubber (SIR)References
J. Edianta, N. Fauzi, M. Naibaho, F. S. Arsyad, and I. Royani, “Review of the effectiveness of plant media extracts in barium hexaferrite magnets (BaFe12O19),†Sci. Technol. Indones., vol. 6, no. 2, pp. 39–52, 2021.
A. U. Rasyid, P. Southern, J. A. Darr, S. Awan, and S. Manzoor, “Strontium Hexaferrite (SrFe12O19 ) Based Composites for Hyperthermia Applications,†J. Magn. Magn. Mater., vol. 344, pp. 134–139, 2013.
Ramlan, Muljadi, P. Sardjono, D. Setiabudidaya, and F. Gulo, “Influence of addition Ba-Ferrite on the hardness, magnetic properties and corrosion resistance of hybrid bonded magnet NdFeB,†J. Phys. Conf. Ser., vol. 1204, no. 1, 2019.
Ramlan, Muljadi, P. Sardjono, Suprapedi, and D. Setiabudidaya, “Mechanical and magnetic properties of flexible magnet Ba-hexa Ferrite,†J. Phys., 2019.
W. S. Sipahutar, William, and Muljadi, “Pengaruh waktu milling terhadap Sifat mikro struktur dan magnet dari NdFeB dengan proses Wet dan Dry milling,†J. Teor. dan Apl. Fis., vol. 9, no. 1, pp. 9–16, 2021.
A. F. dan A. Manaf, “Pembuatan Magnet Permanen Barium Heksaferit Berbahan Baku Mill Scale Dengan Teknik Metarlurgi Serbuk,†Jurnal Sains Materi Indonesia, vol. 5, no. 1. pp. 45–50, 2019.
L. Hou, J. Hui, Y. Yao, J. Chen, and J. Liu, “Effects of Boron Content on microstructure and mechanical properties of AlFeCoNiBx High Entropy Alloy Prepared by vacuum arc melting,†Vacuum, vol. 164, no. December 2018, pp. 212–218, 2019.
C. Rong and B. Shen, “Nanocrystalline and nanocomposite permanent magnets by melt spinning technique,†Chinese Phys. B, vol. 27, no. 11, 2018.
A. K. Karo, A. Handayani, and D. Sudirman, “Aplikasi Resin Epoksi Sebagai Matriks Pada Pembuatan Komposit Magnetostriktif Terfenol-D,†J. Sains Mater. Indones., pp. 115–119, 2019.
M. Mendrofa, P. Sinuhaji, and M. Muljadi, “Study on the Production of Bonded Magnet NdFeB and Polyvinyl Butyral,†J. Technomaterials Phys., vol. 2, no. 1, pp. 25–33, 2020.
A. Shundo, S. Yamamoto, and K. Tanaka, “Network Formation and Physical Properties of Epoxy Resins for Future Practical Applications,†JACS Au, vol. 2, no. 7, pp. 1522–1542, 2022.
Suprapedi, Muljadi, P. Sardjono, and Ramlan, “Effect of silicon rubber composition on mechanical, magnetic properties and microstructures on Neodymium Iron Boron composite,†J. Phys. Conf. Ser., vol. 1120, no. 1, 2018.
K. Nemeth et al., “Synthesis and investigation of SiO2-MgO coated MWCNTs and their potential application,†Sci. Rep., vol. 9, no. 1, pp. 1–11, 2019.
B. J. Rao, C. S. Doyle, M. C. Simpson, E. S. Graham, and C. P. Unsworth, “Selective PEGylation of Parylene-C/SiO2 Substrates for Improved Astrocyte Cell Patterning,†Sci. Rep., vol. 8, no. 1, pp. 1–11, 2018.
C. H. Bok, S. J. Woo, C. Wu, J. H. Park, and T. W. Kim, “Flexible bio-memristive devices based on chicken egg albumen: Au@SiO2 core-shell nanoparticle nanocomposites,†Sci. Rep., vol. 7, no. 1, pp. 1–8, 2017.
B. Y. Chen, C. C. Chi, W. K. Hsu, and H. Ouyang, “Synthesis of SiC/SiO2 core–shell nanowires with good optical properties on Ni/SiO2/Si substrate via ferrocene pyrolysis at low temperature,†Sci. Rep., vol. 11, no. 1, pp. 1–11, 2021.
M. Shakiba et al., “Nylon—A material introduction and overview for biomedical applications,†Polym. Adv. Technol., vol. 32, no. 9, pp. 3368–3383, 2021.
D. Djuhana, M. Muljadi, S. Sunardi, and P. Sardjono, “Pembuatan dan Pengujian Bulk Density, Fluks Magnetik, dan Mikrostruktur pada Hybrid Magnet Berbasis NdFeB / BaFe12O19,†Pist. J. Tech. Eng., vol. 1, no. 2, pp. 25–29, 2019.
T. Jurnal, S. Dan, G. Giyanto, and M. Mulyadi, “Analisis densitas , kuat tarik dan kekeuatan magnet dari rubber magnet yang dibuat dari Ba-Ferrite dan silicon rubber,†vol. 16, no. 02, pp. 227–230, 2020.
P. Sinuhaji, “The Effect of Composite Bonded Magnet NdFeB / BaFe12O19 Composition with an Addition of Bakelite to Physical and Magnetic Properties The Effect of Composite Bonded Magnet NdFeB / BaFe12O19 Composition with an Addition of Bakelite to Physical and Mag,†2018.
License
This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.
Authors who publish with Indonesian Physical Review Journal, agree to the following terms:
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution-ShareAlike 4.0 International Licence (CC BY SA-4.0). This license allows authors to use all articles, data sets, graphics, and appendices in data mining applications, search engines, web sites, blogs, and other platforms by providing an appropriate reference. The journal allows the author(s) to hold the copyright without restrictions and will retain publishing rights without restrictions.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgment of its initial publication in Indonesian Physical Review Journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).
